• Products

  • Contact Us

    OBD2 Toll China

    Emial: obd2013@126.com

    Skype: OBD2

  • Tags

  • Share

  • Opcom OP-Com 2010V Can OBD2 Opel Firmware

    You are here: Home » Products » Car Diagnostic Tool » Opcom OP-Com 2010V Can OBD2 Opel Firmware

    Opcom OP-Com 2010V Can OBD2 Opel Firmware V1.45 Free Shipping
    Item No. SP105-B

    20cm*15cm*2.5cm      ( Inch:7.87*5.91*0.98 )

    OPCOM 2010 diagnostic tool for Opel cars covers almost all Opel cars, even new cars with CAN-BUS based diagnostic, such as Vectra-C, Astra-H, Zafira-B. opcom 2010 lets you read and clear fault codes, support many control units.
    Software version: 2010.08
    Hardware Version: 1.45

    Opcom OP-Com 2010 V Can OBD2 Opel Firmware V1.45


    1. Software Version: 201008
    Hardware Version: 1.45
    2. OP-COM – PC based Opel diagnostic
    3. OP-COM is a PC based diagnostic program.

    OPCOM 2010 Function:

    1. It covers almost all Opel cars, even new cars with CAN-BUS based diagnostic, such as Vectra-C, Astra-H, Zafira-B.
    2. The program lets you to read out and clear fault codes, shows you live data, lets you to perform output test.
    3. The program supports many control units, like Engine, Automatic Transmission, ABS, Airbag, Engine Cooling module, Instrument Cluster, Electronic Climate Control, Body Control Unit, just to name a few examples.
    4. Since Opel uses many pin in the OBD connector, the diagnostic interface works as a multiplexer, and selects the appropriate pin for communication.
    PIN3, PIN7, PIN8, PIN12 = Serial Link (ISO9141, KW81, KW82, KWP2000)
    5. Fault codes will be shown with all available information

    OPCOM 2010 Feature:

    1) Full status information (Present, Not present, Intermittent)
    2) You can print out, save, or copy the fault codes to any other application. From the fault codes window, you can go directly to the measuring blocks window.
    3) The program shows you measuring block information on many control module, you can choose anything from the list on your own.
    4) The program is capable of showing 8 measuring block parameter simultaneously. The sample rate is depends mostly on the communication protocol. For example, older system, like Omega-B X 25 DT Engine (ISO-9141-2) can be very slow, during communication, while newer Multec, or Bosch units are faster (using KWP-2000), and the newest CAN based control units are very fast!

    You can also run output tests on many controllers.

    HSCAN – Dual-wire, High Speed CAN-BUS, 500 kbps
    MSCAN – Dual-wire, Medium Speed CAN-BUS, 95 kbps
    SWCAN – Single-wire, Low Speed CAN-BUS, 33.3 kbps

    Package List:

    1. OP COM Interface
    2. USB Cable
    3. Software and Drivers CD

    Other Items in this category

    Have any question, Please enter the form below and click the submit button.

    2 + 7 = ?
    Please enter the answer to the sum & Click Submit to verify your registration.
    Copyright©2008-2022 www.o-bd.org All Rights Reserved.  
    Sitemap | Top↑